Easy assembly, quiet, and not bad for the price. A few pointers. Install the 2 aaa batteries before mounting. This is done by removing the 4 recessed Phillips screws, not the 4 allens you installed in the last steps. There was a coiled wire taped to the side of the bike, which I had to run up to the handlebars and plug in where the batteries go as well. Once you see where the batteries go, you will see where the wire is that the plug goes to as well. I believe it reads the speed from the wheel. To set from kph to mph, hold down the mode button for about 10 seconds. It will reset once or twice, but eventually you'll see an M on the bottom right, instead of a K. Make sure to peel the blue film off the hand grip, or your pulse reading will not work. Happy riding!
C. Coley –
Yosle –
H. Wolfe III –
What tool fits in this ?? Now. Pictures are are not accurate. Scam . Beware –
Brian –
Carlos –
Tina s –
Miguel Hernandez –